We recommend you read the sections about blade offset and blade depth.Ĭlick "Next" to continue to the next section. Setting up the blade is essential not only for obtaining good cutting results but also in prolonging the life of the blade and to keep the plastic cutting strip smooth.Ĭlick here for an article that explains how to set up your blade and blade holder correctly. If using a roll of media, feed on the back of the cutter.ĭo not forget to feed out the media from the roll so it can move freely through the machine. ![]() If using a carrier mat or smaller pieces of media feed from the front. Serve pra todas que utilizam o mesmo Driver GoldCut, com isso ela corta direto do Corel Draw, no meu caso X8- JINKA Jk, Pelegrin, Agrotama entre outras Chine. Make sure the pinch holders are positioned under the markings or correctly positioned over the grip rollers so that the material will be fed properly. ![]() See the next section for the communication setup. Start with connecting the power cord on a grounded outlet. The steps to assemble the cutting plotter stand may vary. The exception is if you choose to use the USB cable in which case you will need to install the USB>Serial conversion driver (instructions below), but this is for the type of connection and not the plotter itself. ![]() If the cutter comes with a stand, we advise you to check the user manual that came along with the cutting plotter. Signcut and most other vinyl / tint cutting software interfaces with the vinyl cutter directly without installing Windows drivers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |